20%
We strongly encourage users to use Package manager for sharing their code on Libstock website, because it boosts your efficiency and leaves the end user with no room for error. [more info]
Rating:
Author: Russell Kelly
Last Updated: 2016-02-18
Package Version: 1.0.0.0
Category: Measurement
Downloaded: 684 times
Followed by: 2 users
License: MIT license
This project is for the design of a tortoise egg incubator temperature controller. The temperature is regulated by an external heat lamp, which is controlled to maintain the temperature to within a specific range. Temperature is measured using a LM35 temperature sensor.
Do you want to subscribe in order to receive notifications regarding "Tortoise Egg Incubator Temperature Controller" changes.
Do you want to unsubscribe in order to stop receiving notifications regarding "Tortoise Egg Incubator Temperature Controller" changes.
Do you want to report abuse regarding "Tortoise Egg Incubator Temperature Controller".
| DOWNLOAD LINK | RELATED COMPILER | CONTAINS |
|---|---|---|
| 1398172843_tortoise_egg_inc_mikrobasic_dspic.zip [5.40MB] | mikroBasic PRO for dsPIC30/33 & PIC24 |
|
This project is for the design of a tortoise incubator temperature controller. The temperature is regulated by an external heat lamp, which is controlled to maintain the temperature to within a specific range. Temperature is measured using a commonly available LM35 temperature sensor. The controller allows the user to preset the operating temperature range, and alarm set points. For more of my work please visit my webpage at: www.rkelectronics.org
PLEASE NOTE In the bill of materials it is shown that the lamp output kettle socket is male. This is incorrect and should be a female. The mains inlet should also be male not female.
This is the box when opened, you can see that it is quite full inside.
View full image
This is the main board which holds the CPU. However this project consists of multiple daughter boards, including the LM35 sensor card.
View full image
This card interfaces with the LM35 sensor. On board is an operational amplifier 5 stage low pass filter (Fc = 6 Hz) (to remove noise, mains interference and variations from the sensor) and a 12 bit SPI controlled ADC (MCP3201).
View full image
An example of how to easily create your own etch traces, using a toner printout and a laminator.
View full image
